10
IMPORTANT: This appliance is not intended
for use by persons (including children) with re-
duced physical, sensory or mental capabilities
may be different or reduced, or lack of experi-
ence or knowledge, unless such persons are su-
pervised or trained to operate the product by
a person responsible for their safety. Children
should be supervised to ensure they do not use
the devices as toys.
TOOL USE AND CARE
Do not force the power tool. Use the correct
tool for the application. The correct tool will
do the job better and more safely at the rate
that it was designed to work at.
Do not use tools if switch does not turn it on or
off. Any tool that cannot be controlled whith
the switch is dangerous and must be repaired.
Disconnect the plug from the power source
before making any adjustments, changing ac-
cessories or storing the tool. This preventive
safety measures reduce the risk of accidental
starting of the tool.
When the power tool is not in use, store it out
of the reach of children, and do not allow in-
dividuals who are not familiar with the power
tool or these instructions to operate it. Power
tools are dangerous in the hands on untrained
users.
Maintain the power tool. Check for misalign-
ment or binding of moving parts, broken parts,
and any other condition that may affect the
operation of the power tool. If it is damaged,
have it repaired before using. Many accidents
are caused by poorly maintained power tools.
Check for misalignment or bonding of moving
parts, breakage parts, and any other condition
that may affect the tools operation. If you find
a damaged tool, take it to service before use it.
Use only accessories that are recommended by
the manufacturer of your model. Suitable ac-
cessories for one tool, may become hazardous
when are used on another tool.
Keep cutting tools, sharpened and clean. Cut-
ting tools in good condition with sharpened
edges, are less likely to stuck in workpieces or
easier to control.
Is recommendable to use a safety device suit-
able, such a thermal and diferential switch
when you are using an electric equipment.
SERVICE
Tool service must be perfomed only by quali-
fied repair personnel. Service or maintenance
performed by unqualified personnel could re-
sult in a risk of injury.
SPECIFIC SAFETY RULES FOR
TILE CUTTERS
IMPORTANT: This manual is intended to fa-
miliarize you with the technical aspects of this
‘tile cutter’. It is not, nor was it intended to be,
a training manual. Place the machine on a hori-
zontal, non-skid plane.
NOTE: The machine comes with 4 rubber foot-
pads to be installed before the first use.
Before plugging in, make sure that the voltage
indicated on the machine corresponds to that
of the power source
· Wear compliant gloves, anti-noise helmet and
protection goggles during use
· Never use diamond discs that are cracked or
worn.
· Unplug the machine before replacing the dia-
mond disc.
IMPORTANT: Always use continuous crown
diamond disks with the same characteristics as
the original.
Operating frequency should be of 10 min
run, and 15 min of rest.
· Do not expose the machine to rain or use it in
a humid atmosphere.
CAUTION: Depending on the type of tile,
the cooling water may become polluted. In
that case, comply with local standards when
disposing of it.
· Before plugging in the machine, make sure
that the switch is in the OFF position.
· Examine the machine before using, especially
the state of the electrical parts and protectors.
Make sure that the disk rotates freely.
IMPORTANT: Never use the machine with-
out water in the trough. The diamond disk
must splash in water during use.
· Keep the floor around the machine clean and
free of scrap material, oil and grease.
· Keep machine guards in place at all times
when the machine is in use. If removed for
maintenance purposes, use extreme caution
and replace the guards immediately.
CC707 manual.indd 10
28/05/15 15:44
