FEATURES
KNOW YOUR TOOL
Before attempting to use this product, become
familiar with all of its operating features and
safety requirements.
1. BATTERY POWERED GREASE GUN.
2. GREASE CONTAINER (500 cc).
3. HIGH PRESSURE HOSE.
4. GREASE DISPENSER.
5. QUICK CHARGER.
6. BATTERY (x2).
OPERATION INSTRUCTIONS
PRODUCT FEATURES
· 8 500 PSI, Output Grease Pressure
· Grease Output upto 3 oz. (85 g/minute) in
free flow.
· Automatic Air Bleeder & Bulk Loader
· Automatic Pressure Release Valve.
· 30"-High Pressure Hose with Spring Guard
on both ends (prevents hose from kinking).
· High Pressure Grease Coupler.
· An additional 1.5Ah Ni-Cd Battery Pack for
un-interrupted greasing.
· One hour quick charger (each battery charge
provides power to dispense upto 6 Grease
cartridges in free flow condition).
11
E N G L I S H •
User’s manual
CHARGING THE BATTERY PACK
For best performance, do not recharge the new
battery unless it is completely discharged. Re-
charging the battery pack before its complete
discharge will reduce the total work life of the
pack. All New guns come with 80% charge
from the factory and no charging is needed
until it is used and the battery is run down.
As a battery pack approaches the discharged
state, the tool performance drops. This is the
right time to recharge the battery pack. Re-
charging the battery pack before this condi-
tion is reached will reduce the total work life
of the pack. Discharging the pack beyond this
point can damage the pack.
• Before using Grease Gun for the fist time, if
the battery pack is installed in the gun, remove
it by depressing the two battery release but-
tons (one button on each side of battery pack)
and pull battery pack out of gun.
IMPORTANT: Battery temperature will
increase during and shortly after use. Allow
the battery pack to cool to room temperature
before charging otherwise batteries may not
accept a full charge.
• Insert the Battery
Pack into the Charg-
ing Socket of the
Charger. Then, plug
the Charger into the
nearest, grounded,
electrical outlet.
• To start charging,
press the “Set” button
on the Charger.
A green light indicates that the battery is
charging. After termination of the charging
(approx. 1-2 hours), pull charger out of socket
and remove battery.
GETTING STARTED
1. Removing empty cartridge: Remove any
cartridge in the grease gun barrel prior to re-
filling. To check if a cartridge is in the barrel,
first compress the spring by pulling the plunger
handle fully outward & latch the plunger rod
in the slot on the end cap. Remove the grease
gun head by turning it anticlockwise to remove
any empty cartridge.
2. Locking / Releasing the plunger rod: This
gun incorporates a groove in the plunger rod
SET
1
2
3
4
5
6
2371 manual.indd 11
28/05/15 15:12
