urmet domus 1183/5, Manual

Page: 4 / 12

4
−−−−
sec.4b
2 VOICE - Technical Manual
DOOR PHONE APARTMENT STATIONS
user in the same apartment. All the users indoor stations will ring at
the same time in the event of intercom calls to different apartments,
door unit calls and fl oor calls.
The following considerations, should also be taken into account:
Extension 0 rings immediately when a call is received. Extensions
1, 2 and 3 will ring in sequence after each other.
LINE TERMINAL SETTINGS
A line terminal jumper (5) is fi tted in the door phone. Activate the
terminal for devices wired at the end of a line from which another
section does not start from the device terminals (end of line).
PERFORMANCE
CALL RECEPTION
The user’s apartment station will ring with the programmed tone when
a call is received according to the source:
From main door unit
From secondary door unit
Intercom call
Floor calls
From switchboard
The electric lock can be operated from the calling door unit also
without picking up the handset when a call is received.
Indoor station 0 will ring immediately if there are several stations in
the apartment. Extensions 1, 2 and 3 will ring in sequence after each
other.
ANSWERING A CALL
Pick up the handset to establish a conversation with the door phone.
Hang up the handset to end the conversation and switch off the
display.
ADJUSTING THE RINGER SPEAKER (MUTE)
Hold button pressed for longer than 5 seconds; the yellow LED
will blink slowly to indicate that programming mode is selected.
In any case, after 10 minutes the system exits the programming
state and saves the modi fi ed parameters.
Press the button to change the ringer volume
Quit programming mode when the required level is set
(HIGH,LOW,MUTE).
The multicolour LED 2 will blink to indicate mute status.
SUPPLEMENTARY RINGER
The apartment stations are provided with a pair of terminals (S+, S-)
for connecting a supplementary ringer or relay. This ringer is controlled
when any call tone is generated.
FLOOR CALL
The indoor station is equipped with a pair of terminals (CP) for
connecting the fl oor call button. The indoor station will ring with the
set tone for 3s when the button is pressed. Connect this button only
to one indoor station if there are several indoor stations in parallel.
Extensions 1, 2 and 3 will ring in sequence after each other.
INTERCOM CALL FORWARDING
After programming the button for the intercom function, pickup the
handset and press the button.
The following cases can occur according to the calling indoor station
state:
Indoor station free: the calling indoor station will output a
con fi rmation tone (2 beeps) and the called indoor station will ring.
Communication is established when the called user picks up.
Line / System busy: the indoor station outputs a warning tone (4
beeps in rapid sequence). Hang up and try again later.
•
•
•
•
•
•
•
•
•
•
•
CODE 71 CODE 70 CODE 69 CODE 68
CODE 75 CODE 74 CODE 73 CODE 72
CODE 79 CODE 78 CODE 77 CODE 76
CODE 83 CODE 82 CODE 81 CODE 80
CODE 87 CODE 86 CODE 85 CODE 84
CODE 91 CODE 90 CODE 89 CODE 88
CODE 95 CODE 94 CODE 93 CODE 92
CODE 99 CODE 98 CODE 97 CODE 96
CODE 103 CODE 102 CODE 101 CODE 100
CODE 107 CODE 106 CODE 105 CODE 104
CODE 111 CODE 110 CODE 109 CODE 108
CODE 115 CODE 114 CODE 113 CODE 112
CODE 119 CODE 118 CODE 117 CODE 116
CODE 123 CODE 122 CODE 121 CODE 120
*
CODE 126 CODE 125 CODE 124
(*) Con fi guration not allowed, available for future development.
INT : apartment station code
Set a number from 0 to 3 according to the following rules:
The indoor station code must be 0 if there is only one station in
the apartment.
Up to 4 apartment stations can be connected in parallel using the
same user code and different indoor station codes.
ON
1 2
INT=0
1 2
INT=1
1 2
INT=2
1 2
INT=3
The indoor station code is used to identify the single stations of the
same user. This means that intercom calls can be address to the single
•
•
2VOICE COMFORT DOOR PHONE Ref. 1183/5
PERFORMANCE
Ref. 1183/5
2VOICE COMFORT DOOR PHONE