24
DS1058-007A
4.2.2
Acquiring detection devices
Warning:
acquiring the devices is a gradual operation; therefore, if you want that the devices are paired to
the outputs according to a certain order, you have to consider that acquiring sequence is affected by the
fact that the devices are acquired gradually.
Warning:
you cannot acquire devices if radio module 1058/010 is armed.
To make radio module 1058/010 acquire one or more micro contacts or IR detectors:
1.
Set radio module 1058/010 to acquisition mode in following way:
a.
Set DIP switches A1 and A2 to ON.
b. Press
once control pushbutton on radio module 1058/010. Radio module sends out 3 beeps and
LED
(green), indicating that you entered detection devices acquisition mode, and status
LEDs 1÷16 (red), of the inputs to which a number of devices are already paired, go on steady.
c.
Keep pressed for 3 seconds control pushbutton on radio module 1058/010. Radio module sends
out 3 beeps and LED
blinks once to indicate that detection devices can be acquired.
2. Press the programming key of either micro contact or IR detector. The first of status LEDs 1÷16 that is free
goes on and radio module 1058/010 sends out 2 beeps for confirmation. If radio module 1058/010 sends
out one two-tone beep, it means that the limit was reached of devices that can be acquired and that no more
devices can be added.
3.
Repeat from point 2 to acquire more detection devices, or reset both DIP switches A1 and A2 of radio
module 1058/010 to OFF to quit acquisition mode (radio module 1058/010 sends out one two-tone
beep). Radio module 1058/010 automatically quits acquisition mode if no operations are performed for
3 minutes.
4.2.3 Fastening
The microcontact is mounted securing it with screws going through prearranged holes.
Then close the holes with provided white plastic caps. The magnet can be mounted both with the screws
and with provided strip adhering on both sides.
With door or window closed, the distance between micro contact and magnet must not exceed 15 mm.
Magnet position is highlighted on micro contact by two raised dashes.
