84
●
Learning Codes:
Across the bottom of the window are the control
buttons for operating the learning functions. From left to right, these are
described below:
Retry:
This restarts the learning process, it can be used when
attempting to relearn the current butt or if there was an error and
the learning process did not start
Skip:
this skips the current button attempting to be learned on and
selects the next one in line.
Next:
after learning a command and naming it, this button saves
the data and moves to the next button in line and prepares the
system for learning to it.
Save and Close:
after learning a command and naming it, select
this button to save the data and close the learning window.
Stop:
selecting this button stops the learning process and closes
the window.
7. When the status displays learning the system is ready to learn the IR
command from the remote control. Hold the remote that is being learned
from a few inches in front of the hub’s front lens. Then press and hold the
button to learn from. Keep the button pressed until the display in the
learning window updates. If the status changes to successful, enter the
button name and function. Then select the
Next
button or
Save and Close
.
8. Continue to learn as many IR commands, when complete select the
Finish
button.
