12 |
Unpacking and Initial Setup
5.
Wire the receptacle including ground wire.
120V
6.
Plug the fireplace power cord back into the
receptacle and re-install the junction box.
7.
Apply power and ensure connection
was made successfully.
Gas Connection
WARNING:
ONLY PERSONS LICENSED TO WORK WITH
GAS PIPING MAY MAKE THE NECESSARY GAS
CONNECTIONS TO THIS APPLIANCE.
NOTE:
Consult your local authorities codes or the CAN/CGA B
149 (1 or 2) installation code in Canada, or in the USA
gas installations follow either local codes or the current
edition of the National Fuel Gas Code ANSI Z223.1.
3.
Use a 7/16" socket to remove the two 1/4-20 nuts
retaining the electrical junction box and unplug
the fireplace power cord from the receptacle.
4.
Remove the junction box from the fireplace
and run the incoming power wire through
the desired knock-out and into the box.