10 |
Unpacking and Initial Setup
Leg Height Adjustment
(Optional) Urbana units have adjustable legs that can
raise the height, in 1/2" increments, up to an additional
3" (76mm). This may be desired depending on the install
configuration. Adjust as follows:
1.
With help, gently lay the unit on its
A
A
A
A
B
B
B
B
Heat Shield Installation
The fireplace comes with two heat shields that are
necessary for the safe functioning of the fireplace.
Both
heat shields must be attached to the cabinet of the
fireplace prior to installation.
These heat shields are
MANDATORY.
1.
The fasteners (6 total) needed to install the
front heat shield come installed on the shield
itself; use a 1/4” socket to remove the fasteners.
2.
The front heat shield installs behind the top lip
of the cabinet. Use the fasteners to screw through
the cabinet and into the heat shield as shown.
back to access the adjustable legs.
2.
Use a 3/8 socket with 6” extension (minimum) to
access fasteners. Remove side fasteners
(Labelled A).
3.
Remove end fasteners
(Labeled B)
4.
Adjust legs to desired height ensuring all 4
legs are equal. Legs adjust in 1/2" increments.
5.
Reinstall fasteners and bring unit to its feet.
3.
The rear heat shield installs on the cabinet back
using 8 pre-installed screws. Use a 1/4” socket to
remove the fasteners from the shield and mount
the heat shield onto the back as shown.