12
b
uRneR
a
ssembLy
R
emovaL
:
1. Remove the safety screen (see
M
aIntenance
anD
s
erVIce
- s
afety
s
creen
r
eMoVal
on page 10).
2. Remove the door trim (see
M
aIntenance
anD
s
erVIce
- D
oor
t
rIM
r
eMoVal
on page 11
).
3. Remove the glass door (see
M
aIntenance
anD
s
erVIce
- G
lass
D
oor
r
eMoVal
on page 11)
Maintenance And Service
4. Remove log set (if installed).
5.
Remove the bottom steel liner from the firebox (see Figure 8).
6. Remove the Log Grate by loosening the two screws holding the
log grate clamps in place near the front of the grate and sliding
them outwards (see Figure 9).
7. Remove the pilot shield and pilot from the log burner assembly
(see Figure 10).
8.
Remove the two (2) T-20 screws securing the orifice mount
clamp onto the burner (see Figure 11).
9.
Loosen the two (2) T-20 screws securing the burner to the
firebox (see Figure 12). The burner has keyslot holes that
allow the burner to then be removed without fully removing
the screws.
To re-install the burners, follow the steps above in reverse. When
placing the burners back in the unit, be sure not to move the
air shutter. Do not over tighten the burner screws or they
might strip; just get them snug.
Figure 8: Bottom Steel Liner Removal
The burner will need to be removed for maintenance and fuel conversion. Follow the procedure carefully.
Proceed only when the unit has completely cooled down.
Figure 9: Log Grate Removal
Figure 10: Pilot Shield & Pilot Removal
Figure 11:
Orifice Mount Clamp
