DAILY CHECKS
ACTION
NOTES
Hydraulic System
Top up with machine standing on level ground in
the travelling position. Fill oil using the return line
filter on top of the tank. Oil must be at the bottom
mark on the dipstick. Look for oil leaks.
Use SHF22 oil or
equivalent. Change oil
and filter every 6
months
I.C. Engine
Check oil, filter and fuel. Check for leaks. Check
battery. Top up with distilled water only. 6 mm
above plates.
See OEM manual for
more information
Level Gauge
Check that level gauge is present and secure
Physical damage
Check for physical damage to the booms, tie
bars, basket, slew and the chassis. Check all
warning labels are in place
Do not use damaged
machine
Nuts, Bolts, Fittings Check for missing and loose nut and bolts.
Replace immediately
Locking pegs
Check that all locking pegs are present. Check
that no shafts are seized.
Broken peg = seized
shaft
Battery & Charging If fitted. Check operation of charger. Record
specific gravity of each cell. Clean top of battery.
Clean and check terminal
Emergency stop
Check that all emergency stop switches are
working
Turn to release
Electrical system
Check for correct operation of the complete
electrical system
Electrical Safety
system
Check that you can not operate the booms until
outriggers are down and in contact with ground.
Check that you can not raise the outriggers with
top or bottom boom elevated.
Hydraulic Safety
system
Check that all emergency lowering valves work.
Check emergency slew. Check emergency
handpump
Wheels
Check tyres for damage. Wheel nuts and tyre
pressure
55PSI 3.8 Bar
Running gear
Check parking brake. Check overrun device.
Check for damage
Trailer lights
Check for correct operation if towing
WEEKLY CHECKS Depending on use and operating condition
different intervals may be acceptable
Lubrication
All grease nipples. Depending on machine use
and operating condition different intervals may
be acceptable.
Slew Gear
Check slew gear for excessive wear. Grease
MONTHLY CHECKS Can be done 6 monthly depending on operating
conditions
DC motor
Check and replace motor brushes if machine is
used heavily
2/3 worn = Replace
Wheel bearings
Check for wear - Do checks at every 3000 miles
6 MONTHLY
CHECKS
Thorough Inspection Contact UpRight or its local representative.
Change oil and filter !
MAINTENANCE SCHEDULE
Page 11
Summary of Contents for POWERED ACCESS TL34
