UPnRIDE Powered Wheelchair User Guide
Page 70 of 90
Document Version: UM-01-01_Rev B5
8.4.2.
System Accessories - Harness, Hip Belt, Back Support and Seat Cushion
Clean according to the manufacturer’s instructions for each accessory. Manufacturer’s cleaning
instructions for the ordered accessories are supplied along with the accessories.
Caution:
Do not use acetone-based products to clean the UPnRIDE
System surfaces that touch the body may be cleaned periodically using a dampened cloth with
an alcohol-based disinfectant.
Straps that are torn, worn, or contaminated should be discarded and replaced with new ones.
Please contact UPnRIDE to perform this service.
8.4.3.
Coated Metal
For regular cleaning, wash coated metal surfaces with a soft cloth soaked in detergent and warm
water. Rinse thoroughly and dry.
Remove scuff marks from low-gloss coatings with pre-softened paste wax. Follow the
manufacturer’s instructions.
8.4.4.
Plastic
For normal cleaning, wash plastic surfaces with a soft cloth soaked in mild detergent and warm water.
Rinse thoroughly and dry with a soft cloth. Do not use solvents or abrasive household cleaners.
8.5.
Battery Care
Refer to chapter 4: Charging the Battery.
8.6.
Safety Inspection
8.6.1.
Condition of the Tires
Regularly check and verify that the tires are in good condition (complete, will not slide on smooth
terrain).
8.6.2.
Securing Belts and Brackets Inspection
Regularly check the condition of the securing belts and knee supports for any excessive wear or damage.
These include the harness, hip belt, foot straps, pads on knee supports and the mechanical parts of the
knee supports.
If damage is found, contact your authorized UPnRIDE dealer before operating the wheelchair.
