BakerTop
™
English
13
Alarm messages:
When a condition arises which prevents the appliance from operating at all, an ALARM signal is displayed and the
appliance must be switched to its STOP status.
The device stops operating and the ALARM! message appears on the oven display until the problem is resolved.
If the device is operating when the ALARM status occurs, it will shut down and the alert corresponding to the
detected problem will be displayed. To resolve a problem of this type, contact an Authorized Assistance Centre.
Once the problem has been resolved, the appliance can be reactivated by pressing the «START/STOP» button.
If any other devices/accessories are connected to the oven, these will continue to operate normally unless the
alarm corresponds to a specific device that prevents its continued operation.
DISPLAY
DESCRIPTION
EFFECT
POSSIBLE PROBLEM
PROBLEM SOLUTION
AL01
Error on the data
taken by the prover
probe.
Prover STOP
Chamber probe not
correctly connected
Contact the Customer
Assistance Service
Chamber probe damaged
Contact the Customer
Assistance Service
Prover board damaged
Contact the Customer
Assistance Service
AL02
Communication
between the oven
and the prover cut
off
Prover STOP
Cable between the oven and
the prover interrupted or
not correctly connected
Contact the Customer
Assistance Service
Oven board damaged
Contact the Customer
Assistance Service
Prover board damaged
Contact the Customer
Assistance Service
Electrical noise level very
high
Contact the Customer
Assistance Service
AL10
An error was
detected in some
essential parameter
prover board
Prover STOP
Prover board damaged
Contact the Customer
Assistance Service
Wrong parameters
Contact the Customer
Assistance Service
N.B.
Every time the oven is started electrically, and every time the control P.C.B. exits STANDBY mode, the
control P.C.B. is scanned (which appear on the display, if present) for ALARM / WARNING conditions of
the oven and all other accessories connected .
Oven-user communication
