S a y f a
| 17
Technopel, Pelet Yakıtlı Sıcak Su Kazanı İşletme ve Bakım Kılavuzu
Cleaning:
Cleaning must be done when the boiler is cool down. The electrical connection should be cut off in
the cleaning stage. Please consider the below items while cleaning the boiler:
• It is useful to clean the front cover of the boiler at the end of each burning period. It is
recommended to use cleaning equipment supplied with the boiler, if necessary.
• The Control board should be protected from dust, moisture, and water.
• The sheet body part of the boiler can be cleaned, if necessary.
Maintenance:
We strongly recommend to contact our authorized technical service for boiler, plumbing, electrical
connections, and chimney maintenance before each operating season. Never perform maintenance
without the assistance of a specialist.
ALERT
Close main electrical supply
ALERT
Please work under the
supervisor's control.
ALERT
Wear the safety gloves
ALERT
Wear the dust mask
WARNING
Possible finger and hand injuries
due to automatic fan operation
WARNING
Possible finger and hand injuries
due to automatic feeding gearbox
WARNING
Possible finger and hand injuries
due to sharp sheet edge
WARNING
Possible injuries due to rotational
tools
TROUBLESHOOTING GUIDE
PROBLEM
POSSIBLE CAUSE
SOLUTION
Insufficient Heating
Heat transfer surface may be
covered by smoke
Poor quality fuel may be used
Pump may not work
Insufficient insulation of the living
place
Not able to shift modes in the
control board.
Please clean the boiler surface. (boiler
should not work)
Please change the fuel before loading,
take a few quantities and try to adopt
to the proper fuel type
Contact with authorized technical
service, ensure the electrical plug
connection to the main fuse
Increase the insulation of the place
where the boiler is installed
Please switch to the automatic mode
with using menu button
Unsatisfied
Combustion of the
Pellet Boiler
Low combustion air
Ensure the pump is working
Make sure that air suction pipe is not
clogging
