MECHANICS MAINTENANCE
2.
MOTOR:
Check the motor (Figure 13 [6]) for overheating, noise and excessive end play of the shaft.
Replace the motor if defective.
3.
BOWL LIFT ADJUSTMENT:
(Figure10)
a. Place the 12 quart mixing bowl on the bowl support (Figure 1 [17]) and the 12 quart batter beater
on the beater head shaft (Figure 1 [1]).
b. Raise the bowl support to the up position.
c. Check the clearance between the bottom of the bowl and the lowest point of the batter beater.
The clearance should be 3/16 inch, plus or minus 1/16 inch.
d. If adjustment is required, disconnect the electrical power supply cord, loosen the hex head cap
screws (Figure 10 [13]) and raise or lower the bowl until the correct clearance is obtained.
Retighten the screws.
Hex Head
Cap Screws
Page 2.2
