DRIVE ASSEMBLY
(Figure 13)
DISASSEMBLY:
1.
WARING:
DISCONNECT THE ELECTRICAL POWER SUPPLY CORD.
2. Remove the mixer top cover (Figure 14 [9]) per section 2, mechanics maintenance “REMOVAL
OF TOP COVER” instructions on page 2.4.
3. Remove the rear access panel (Figure 14 [11]).
4. With the motor OFF and in low speed, shift to high speed and back to low speed.
5. Remove the nut and washer (Figure 13 [4 & 5]) and remove the belt retainer [12].
6. Unwrap the belt from the driven pulley [13] and pull it from the vari-speed pulley [15].
7. Loosen the set screw on the driven pulley [13] and remove the pulley.
8. Disconnect the motor cable [7] from the contactor/starter and from the ground stud. Remove the
nuts securing the cable clamps.
9. Remove the screw [20] and remove the connecting rod assembly from the motor mount [2].
10. Remove the nuts and washers [4 & 5] and remove the straps [3] and rails [1].
11. With the motor rotated so the shaft is pointed up, remove the motor from the mixer housing.
12. Remove the connection cover plate from the end of the motor and disconnect the motor cord.
13. Loosen the set screw and remove the vari-speed pulley [15] from the motor shaft.
14. Remove the nuts and washers [4 & 5] and remove the motor from the motor mount [2].
REASSEMBLY:
15. Reassemble the motor assembly in the reverse of the above procedure. The following guidelines
should be observed.
16. Make sure the motor rotation and voltage are correct when a new motor is being installed.
17. Grease all sliding surfaces of the motor slide assembly.
18. Be sure the motor mount [2] fits tightly between the rails [1]. First tighten the rail [1] and strap
[3] closest to the front of the mixer housing. With the motor mount firmly held against this rail,
install the second rail and strap against the motor mount and secure them with the washers and
nuts [4 & 5].
19. Adjust the belt tension per the procedures described in Mechanics Maintenance Page 2.1.
Page 7.1
