Univex RDRE Series, Instruction Manual

Page: 20 / 44

RDRE - electric version - gas version - Page 18
Cart
Insertion
- Set the time for the humidification cycle.
- Completely open the door.
- Check that the steam extractor starts working.
- Push the cart into the oven until the upper bearing of the cart enters the housing of the hook.
- Close again, and turn the door handle clockwise until it is locked horizontally.
Extraction
- An acoustic signal will advise you that the set cooking time has expired.
- Begin taking the products out of the oven as follows:
- Release the door, and leave it ajar for a few moments. This will allow any residual steam to be extracted.
- Now open the door completely. Using heat resistant gloves, extract the cart.
- Close again, and turn the door handle clockwise until it is locked horizontally.
INSTRUCTIONS FOR USE
SAFETY INSTRUCTIONS FOR THE USER
!
Attention!

Only after completing all connections, the unit is ready for commissioning.

The unit can be safely operated only if the following instructions are adhered to.

The user may use this appliance only after he has been properly instructed on its use and operation.

Coverings or parts of the unit which can only be removed with the aid of a tool must absolutely not be
removed.

The unit must be monitored while in use.

During operation, the door becomes hot. Be very careful with it.

Be very careful when opening the door during operation or when the unit is hot, as hot vapours may be
released by it!

Protect the unit from freezing temperatures.

All work concerning installation or repair of the unit are to be performed by qualified personnel in
compliance with current standards.
At least once a year, have the unit checked by qualified personnel from the manufacturer. For this
purpose we suggest stipulating a service contract.

The unit must be cleaned on a daily basis.

The unit is not protected against splashes of water. Therefore, do not use direct or pressurized jets of
water

Note: The noise level at in the workplace is less than 70 dB (A). This information is required for certain
national safety standards.
Delayed start: allows the operator to perform start-up and hence the pre-heating phase at a certain time by
setting the day and time using the programming knob. Enter the menu to set in order the day of the week, start-
up time and enabling.