Univex RDRE Series, Instruction Manual

Page: 25 / 44

RDRE - electric version - gas version - Page 23

To move from one “Step” to another, press the key.

Once the setting of the desired Steps (max 5) has been completed, the programme can be stored by
pressing the key for 3 seconds. The buzzer confirms the performed operation.
 The next phase consists in naming the programme which has just been stored. The legend “name”
appears on the display. Scroll through the letters using the “ + ” and “ - “ keys, moving on to the next one
with the key. You will have 16 characters available. Once the procedure is finished, confirm the
operation by pressing the key for 3 seconds.
EXECUTING A CUSTOMIZED PROGRAMME:
To execute a programme stored by the user, proceed as follows:
 Press the key and use the “ + ” and “ - “ keys to select the desired programme. Confirm the selection
by pressing the key. Then press the key to execute the baking programme. During execution of
the programme, the baking parameters will not be modifiable. You can stop the baking cycle before it's
programmed to end simply by pressing the
key for 3 seconds.
To exit the menu, press the key. In this manner, you will return to the main menu of the control.
PRESET PROGRAMMES:
The electronic control of the Rotorbake Series ovens contains 12 preset baking programmes which are suitable
for cooking various types of food. These programmes can be called up using the following procedure:
 Press the key and select the desired baking programme using the “ + ” and “ - “ keys. Confirm the
selection by pressing the key.

Select the degree of baking, increasing or decreasing it (using the keys “ + ” and “ - “, within the range
permitted by the programme), the baking parameter will flash as follows.
Thus using the “ + ” and “ - “ keys, you can change the parameter set by the programme.

Press the key to confirm the modification of the baking time. The aforesaid setting will be effective
for this baking cycle only. To make the programme change permanent, on the other hand, press the
key for 3 seconds. The successful modification will be indicated by an acoustic signal.

To start execution of the programme, press the key. During execution of the programme, the baking
parameters will not be modifiable. You can stop the baking cycle before it's programmed to end simply by
pressing the
key for 3 seconds.

To exit the menu, press the key. This way, you will return to the main menu of the control
.
Depending on the cooking mode set in the programme, during the cooking cycle of the oven, only the time (or the
temperature, in case of probe sensor) will be displayed on display 1.