30
STEP 2
Additionally, if you want, wheels can be added to
the device. To assemble them, place the wheel
holder and screw it to the base in its corresponding
holes. Make sure that the wheels are well adjusted
and parallel to the base.
STEP 3
3-1. Place the bar on top of the brackets.
3-2. Use 6 large screws and flange nuts (M6) to attach the bar to the
bracket. Tighten screws and nuts.
STEP 4
Place the tank housing on the result of steps 1,2
and 3.
STEP 5
Note: If for proper alignment, loosen each screw
before assembly and retighten once all parts are
aligned.
Before proceeding to step 5, remove protective
cover before assembling the parts.
5-1. Slide two reflector panels. Insert one M6x10 (II)
type screw. Slide the washer (HH) over the screw
thread (II) and place the cap nut (JJ)
