Univers by FTE U4123E, User Manual

Page: 33 / 50

PAG . 33
English
rev 1.0
OSD 64
SYSTEM SETUP
5.2. TV SYSTEM
When you enter the “TV System” menu you will see the screen
like below (OSD 64):
1. Display Mode is used to switch the display mode. You can
select from Auto / PAL / PAL-M / NTSC 3.58/NTSC 4.43.
Press [
] to select the desired mode.
2. Aspect Mode is used to switch the screen aspect ratio mode.
You can select from Auto / 4:3 PS / 4:3 LB / 16:9. Press [
] to select the needed mode.
3. Video Output is use for switching the screen aspect ratio
mode. Now we provide below options: RGB / CVBS. You can
press [
] key to select each mode circularly.
4. VCR Loopthrought: If there is a VCR connected to the recei-
ver and, the receiver is connected to the TV, user can choose
what prefer to watch on TV when both equipments are connec-
ted at the same time. If the selection is “VCR master”, the VCR
will be showed even the receiver is on. If the selection is “STB
master”, the receiver will be showed on the TV.
5. Standard Mod.: To choose the modulator output standard.
Using [
] you can chose between: PAL-BG / PAL-I /
PAL-DK / NTSC.
6. RF Channel: This option allows you to determine the initial
channel that the built-in modulator is supposed to occupy. This
is important in the case that you wish to connect the receiver to
an existing network.
The output range is from channel 21 to 69. Press [
] to
change the value.
7. In HDMI Mode, you can choose the number of lines and the
scan mode of the video signal you are sending by the HDMI
connector. Through the arrows [
], select among: 576P /
480P / 576 I / 480 I. (P: Progressive, I: Interleaved)
Note: If you have the HDMI output connected and you select
the progressive mode, the SCART output is automatically disa-
bled.
8. Press [Exit] to close the “TV System” menu.
5.3. TIME & TIMER SETTING
When you enter “Time” “Local Time Setting” or “Sleep Timer” a
menu with three items will be opened (OSD 65). Use [
]
to select between the three options and confi rm with [OK].
5.3.1. TIMER
Select “Timer” item and press [OK] to enter the “Timer list”
menu (OSD 66).
The current time will be displayed in the fi rst column. If the
current time is incorrect, please modify it with the [Number]
buttons at the “Time” menu.
1. Timer Number: You can press [
] to set the Timer
number. There are totally 8 timers.
OSD 65
OSD 66