English
PAG
.
14
rev 1.0
PANEL & REMOTE CONTROL DESCRIPTION
1. PANEL & REMOTE CONTROL DESCRIPTION
1.1. FRONT PANEL DESCRIPTION
1. POWER: Switches the receiver on, or enters standby mode. To completely switch off the receiver,
you have to use the switch on the back of the receiver.
2. LOCK LED: Indicates a suffi cient signal level at the IF IN input.
3. POWER LED: Indicates that the mains voltage (90-230 VAC) is available.
4. DISPLAY: 4 Digits to display the program numbers.
5. IR-SENSOR: Reception sensor for the IR remote control signals.
6. CH+/-: These buttons allow changing the current channel.
7. Conditional Access: FELEC-CAS
8. USB: Connector for external USB 2.0 HighSpeed devices.
1. IF IN: Satellite input.
2. VIDEO / AUDIO: HiFi Outputs for stereo set or monitor
3. OPTICAL S/PDIF: Optical output for digital audio (AC3).
4. TO TV: Modulator output for the connection to a TV set.
5. ANT IN: Antenna input for the terrestrial antenna.
6. RS-232: Serial Port allowing software upgrades.
7. AC IN: Mains input cable.
8. POWER ON/OFF: Allows to completely switching off the receiver.
9. HDMI: HDMI Output
Note: If you have the HDMI output connected and you select the progressive mode, the SCART
output is automatically disabled.
10. IF OUT: Satellite output for cascading to other devices.
Note: The operation of another receiver at the same time is only possible with limited channel
selection.
11. TV SCART: Output SCART for the connection to a TV set.
12. VCR SCART: Output SCART for the connection to a VCR set.
13. COAXIAL S/PDIF: Coaxial output for digital audio (AC3).
1.2. REAR PANEL DESCRIPTION
1
3
2
4
5
6
7
8
1
2
3
4
6
7
10
9
13
5
11
8
12
Summary of Contents for U4123E
Page 1: ...U4123E ...
