Control connection
43
04/2019 - V01
DS 400.2
Enco
der
TT
L co
nnec
tio
n
5.7
Encoder TTL connection
Only for Version IN
DSx-BAx-DPC/E-DS-400-Enco-TTL-Anschluss-400
ITTL Incremental encoder (Encoder)
with 2 counter tracks and 1 zero track
plus 3 rotor position tracks. Counter
tracks with or without push-pull
output
.
Without a push-pull pulse a connecting
adapter must be used.
The counter input corresponds to
RS485.
Max. counting frequency 500kHz.
The incremental encoder is
galvanically connected with the device
zero (GND).
Supply voltage 5V is provided by the
servo.
DS/BAx/DPC - DS-400-stecker-encoin
Use only motors with TTL incremental encoders and rotor position tracks which have been
approved by the manufacturer. Observe the motor specific connection data sheet (IN)!
Connector
X7
15 pole D-connector
Connecting cable
10 signal conductors, shielded
min. cross-section 0,14 mm
2 supply lines
min. cross-section 0,5 mm
For link chains use appropriate cables!
Cable length
for >25m the cross-section fot he cable used must be increased by one
grade
Shield connection
across the connector X7
connect the shield tot he
connector housing
across the motor connector
connect the shield tot he
connector housing
Setting parameter
see Software-Manual DS
Steckerbelegung
Lötseite
M Sitftkontakt
Temperatur
Motor
5
12
TEMP
M
ot
or
-S
te
ck
er
D-Stecker X7
TMS
E
nc
oder
T
T
L
10
VCC +5V
1
A
4
A
2
B
11
B
3
N
9
N
13
ROTOR1
14
ROTOR2
15
ROTOR3
TEMP
6
DS xx/BAxx
VCC +5V
GND
GND
4k7
VCC +5V
D-connector X7
M
ot
or
-c
on
ne
ct
or
Schirm am Steckergehäuse
Shield at connector housing
Schirm am Steckergehäuse
Shield at connector housing
