Mechanical Installation
21
04/2019 - V01
DS 400.2
In
st
all
at
io
n
3.4
Installation
DS-400-montage-2
Supply air temperature 0 to max. 45°C
In order to achieve good EMC values, it is recommended to use bright, unpainted
mounting plates. The bright surface of the device's rear panel ensure a good surface-to-
surface contact.
The signal lines and the power supply lines must be routed in separate trunkings with rectangular
crossings (spatial separation of the disturbance coupling).
Installation instruction
DS-400-schrank2-block
Recommended fixing screw
DIN 912 M5x12 with safety washer
Bore the threaded M5 holes at a right angle
distance of 312 mm
Turn in the M5x12 screws.
Distance to the rear panel of the switch cabinet
approx. 4 mm.
Position the upper edge of the device (1) and
push it up against the stop (2). Then push the
lower part of the device against the switch
cabinet's rear panel (3) and lower it (4).
Fasten the screws.
Enough space for the discharged ventilation air
Power line
size 1
size 2
signal line
Si
gn
al
li
ne
