Unitek BAMOCAR-D3, Manual

Page: 5 / 46

Technical Data
5
The user has to ensure :
That the drive will be led to a safe operating condition,
after an equipment failure
-due to malfunction of controlling or regulating unit
Machines, equipments and vehicles are to be further provided
with equipment independent monitoring and safety devices.
Un-earthed systems ( for ex. vehicles) must be protected
with an insulation monitor.
No danger shall arise for humans and property .
Assembly
-only in non-energized condition
-by trained personnel.
Installation work
- non-energized condition
-only by trained electrical personnel.
Safety regulations
Observe safety-regulations
Setting up
Setting up and programming
- to be done by trained personnel with knowledge and in electronic drives and software.
-observe programming instructions.
Safety regulations
Observe safety regulations.
Installation :
In case of nstallation in machines, equipments and vehicles, commissioning the equipment
for the intended purpose is prohibited , until it has been ascertained , that the machines,
equipments or vehicles comply with the EC guidelines for machines 2006/ 42/ EG, the EMC
guidelines 2004/ 108/ EG and ECE-R100.
The EG- guideline 2004/ 108/ EG with emc regulations EN61000-2 and EN61000-4
pertaining to installation and test conditions mentioned in chapter emc instructions are
complied with.
A manufacturer’s clarification can be requested for.
Compliance of limiting values , laid down by the emc legislations , is the sole responsibility
of vehicle manufacturers, equipments or machines.
Quality assurance equipment serial numbers , along with date of testing are archived by
the manufacturer for 10 years. Test protocols can be requested for.
Safety symbolsttention :
Danger to life
Warning :
high voltage important
Saf
et
y
ins
tr
ac
tions