![background image](http://html1.mh-extra.com/html/united-states-stove/ashley-heritage-5700/ashley-heritage-5700_owners-manual_4031017015.webp)
-15-
4) Check that both augers and the exhaust blower are operating (the room air blower will not start at this time).
DO NOT open the viewing door, the
auto-start igniter
will get very hot during this test. The stove will auto-
matically shut down after approximately 23 minutes.
START-UP PROCEDURE
Never use gasoline, gasoline-type lantern fuel, kerosene, charcoal lighter fluid, or similar liquids to
start or ’freshen up’ a fire in this stove. Keep all such liquids well away from the stove while it is in
use.
1) Verify that the hopper is clean and free of foreign matter.
2) Verify that all of the required exhaust/inlet connections have been made in accordance with this manual and
that the stove is plugged into an outlet (an outlet surge protector is highly recommended).
3) Fill the hopper with wood pellets; do not allow any part of the bag or any other foreign material into the hopper,
as this may jam the augers.
4) Ensure that all pellet matter is cleared from the hopper gasket seating surface.
5) Close the hopper lid and secure the latch.
6) Make sure that the viewing door and ash pan slides are securely closed (the safety pressure switch will not allow
the stove to feed fuel if there is no draft pressure inside the stove) .
7) Press the
“ON”
button on the control pad and set the
“HEAT SETTING”
to
“5”
.
8) The stove will begin to feed fuel and the
auto-start igniter
will ignite the fuel in approximately 5 minutes.
Once a consistent flame has been established, you can adjust the
“HEAT RANGE”
and
“BLOWER SPEED”
on the
control pad to your desired settings. (Note: The room air fan will not function until the heat exchanger in the stove
reaches the factory preset temperature).
SHUT DOWN PROCEDURE
Press the
“OFF”
button on the control pad to put the stove in shut down mode. At this time, the red light above the
pad will illuminate. Once this is done, the top auger will stop feeding pellets to the bottom auger, but the room air
fan, exhaust blower, and bottom auger will continue to operate. When the internal temperature of the unit drops
below the factory preset temperature, the room air fan, exhaust blower, and bottom auger will cease to operate.
The red light will then shut off and the unit will be completely shut down.
The hotter the unit is during its operation, the longer it will take for the stove to complete the shut down cycle. If
the stove stays on for more than 2 hours after pressing the
“OFF”
button and you are sure that the fire is out, the
stove can be unplugged from the outlet. After approximately 10 seconds, the unit can be re-connected to the
power source and the control board will be reset.
First Fire:
Adjust the
“HEAT RANGE”
and
“BLOWER SPEED”
to a
“5”
setting and allow the stove to
operate in this manner for approximately three (3) hours (or more if necessary), allowing the stove to “cure
out” as the paint and oils from the manufacturing process burn off. We recommend that you open doors
and windows in your home during this process.
OPERATION
WARNING: Never shut down this unit by unplugging it from the power source.
Summary of Contents for Ashley Heritage 5700
