![background image](http://html1.mh-extra.com/html/united-states-stove/ashley-af1300e/ashley-af1300e_owners-installation-and-operation-manual_4017385004.webp)
-
4
-
Safety
•
WARNING: Do not operate with fuel loading or ash removal doors open.
•
Do not connect this unit to a chimney flue serving another appliance.
•
WARNING DANGER: Risk of fire or explosion. Do not burn garbage, gasoline, naphtha, motor oil, or other
inappropriate materials. Do not use chemicals or fluids to start the fire.
•
WARNING: Risk of fire. Do not operate with flue draft exceeding .060” water column/14.93 Pascals. Do not
operate with fuel loading and ash removal doors open. Do not store fuel or other combustible materials
within marked installation clearances. Inspect and clean flues and chimney regularly.
•
CAUTION: Hot surfaces. Keep children away. Do not touch during operation.
•
The heat exchanger, flue pipe, and chimney must be cleaned regularly to remove accumulated creosote
and ash. Ensure that the heat exchanger, flue pipe, and chimney are cleaned at the end of the heating
season to minimize corrosion during the summer months. The appliance, flue pipe, and chimney must be
kept in good condition. These instructions also apply to a draft inducer if used. To prevent flame or smoke
spillage, the slide baffle must be pulled out and the fuel loading door left cracked for 10 seconds prior to
opening door fully. Load fuel carefully or damage may result.
•
Hot while in operation. Keep children, clothing and furniture away. Contact may cause skin burns.
•
Do not use chemicals or fluids to ignite the fire.
•
Do not leave the furnace unattended when the door is slightly opened.
•
Do not burn garbage, flammable fluid such as gasoline, naphtha or motor oil.
•
Always close the door after the ignition.
•
Consult your municipal building department or fire officials about permits, restrictions and installations
requirements in your area.
•
INSPECT FLUE PIPES, FLUE PIPE JOINTS, AND FLUE PIPE SEALS REGULARLY TO ENSURE THAT SMOKE AND FLUE
GASES ARE NOT DRAWN INTO, AND CIRCULATED BY, THE AIR-CIRCULATION SYSTEM.
•
CAUTION: CLEAN OUT OF THE HEAT EXCHANGER, FLUE PIPE CHIMNEY, AND DRAFT INDUCER, IF USED, IS
ESPECIALLY IMPORTANT AT THE END OF THE HEATING SEASON TO MINIMIZE CORROSION DURING THE SUMMER
MONTHS, CAUSED BY ACCUMULATED ASH.
Unpacking And Preassemble
UNPACKING
1.
Remove all packaging from the furnace.
2.
Remove the supplied parts from the furnace.
BRICK ALIGNMENT
Inspect for any damage. Ensure that the bricks and
ash plug are positioned correctly and not broken (see
illustration for proper brick arrangement).
TOOLS AND MATERIALS NEEDED FOR INSTALLATION
The following is a list of tools and materials needed to
install your furnace.
•
7/16” socket wrench.
•
5/16” socket (Best if using a power drill and a socket
bit).
•
Pair of pliers or channel-locks.
•
Power drill with an 1/8” drill bit to install sheet metal
screws into connector pipe..
•
Sheet metal screws.
•
Non-combustible floor protector as specified in this
manual.
•
All chimney and chimney connector components
required for your particular venting installation..
•
Electrical wiring tools and supplies.
•
Ductwork for supply and return air.
Proper Fire Brick Alignment
1
2
3
6
5
4