UNITED OFFICE UAVS 300 A1, Operating Instructions And Safety Instructions

Page: 29 / 116

■ 26 │
GB│IE
UAVS 300 A1
Clearing a material blockage
♦ Move the REV/OFF/AUTO/FWD switch 8 to the REV ("reverse") position
if the material being shredded causes a jam . The appliance now goes into
reverse and the material is ejected .
♦ Alternatively, move the REV/OFF/AUTO/FWD switch 8 to the FWD
("forward") position if the material causes a blockage . The appliance is now
in forwards operation and the material that is being shredded is pulled in
again .
♦ Move the REV/OFF/AUTO/FWD switch 8 to the OFF position as soon as
the jammed material has been ejected .
Turning the appliance off
NOTE
► We recommend that you switch off the appliance and let it cool down for
about 30 minutes after 3 minutes of operation to prevent overheating .
♦ Switch the appliance off by moving the REV/OFF/AUTO/FWD switch 8 to
the
OFF
position . The
power
lamp
6
goes out .
Overheating protection
This appliance is fitted with overheating protection . If the motor overheats due to
overloading, the appliance switches itself off automatically . The
overheat
lamp
7
lights up permanently red until the motor has cooled down sufficiently .
If this occurs, do the following:
WARNING! – RISK OF INJURY!
► Pull the power plug out of the power socket to prevent unintended starting
of the appliance .
♦ Switch the appliance off by moving the REV/OFF/AUTO/FWD switch 8 to
the middle OFF position .
♦ Empty the waste collectors w / e .
♦ Allow the appliance to cool down for about 30 minutes .
♦ Replace the plug in the mains power socket .
♦ Switch the appliance on by moving the REV/OFF/AUTO/FWD switch 8
to the AUTO position . The overheat lamp 7 no longer lights up once the
appliance has cooled down sufficiently .