UNITED OFFICE UAVS 300 A1, Operating Instructions And Safety Instructions

Page: 31 / 116

■ 28 │
GB│IE
UAVS 300 A1
♦ Remove any residue left in the cutting openings 2 / 9 or cutting blades
with a suitable object (e .g . brush or tweezers) . Ensure that the appliance is
unplugged before doing this .
♦ Clean the surfaces of the appliance with a soft, dry cloth .
♦ Use a lightly moistened cloth and a mild detergent to remove stubborn dirt
residues from the appliance surface .
Storage when not in use
♦ If you decide not to use the appliance for a long period, disconnect it from
the mains power supply and store it in a clean, dry place away from direct
sunlight .
Troubleshooting
If there is a jam in the appliance
This means that you may have attempted to feed too much paper into the appli-
ance (max . 10 sheets 80 g/m
2 paper) .
♦ Move the REV/OFF/AUTO/FWD switch 8 to the REV position if the paper
causes a blockage . The appliance now goes into reverse and the material is
ejected .
♦ Alternatively, move the REV/OFF/AUTO/FWD switch 8 to the FWD
position if the paper causes a blockage . The appliance is now in forwards
operation and the material that is being shredded is pulled in again .
♦ Pull the paper out of the appliance and then move the REV/OFF/AUTO/
FWD switch 8 to AUTO .
The appliance is now ready for use again .
If the appliance suddenly stops working
This means that the appliance has overheated and the automatic safety cut-out
has activated itself . The
overheat lamp 7 lights up permanently red .
♦ Move the REV/OFF/AUTO/FWD switch 8 to the OFF position .
♦ Remove the plug from the mains power socket .
♦ Allow the appliance to cool down for about 30 minutes .
♦ Replace the plug in the mains power socket .
♦ Switch the appliance on by moving the REV/OFF/AUTO/FWD switch 8
to the
AUTO
position . The
power
lamp
6
lights up permanently blue .
The overheat lamp 7 remains off when the appliance has cooled down
sufficiently .