41
© 2015 unitech Electronics Co., Ltd. All rights reserved.
unitech is a registered trademark of unitech Electronics Co.,Ltd
4.8 Reverse Output Characters
Disable *
Enable
4.9 Setup Deletion
To setup the deletion of output characters:
1. Scan the label of the desired set below.
2. Scan the label of the desired symbology.
3. Go to the Numeric Bar Codes in Appendix A, scan label(s) that represents
the desired position to be deleted.
4. Scan the “Complete” label of “Character Position to be Deleted”.
5. Go to the Numeric Bar Codes in Appendix A, scan label(s) that represents
the number of characters to be deleted.
6. Scan the “Complete” label of “Number of Characters to be Deleted”.
Repeat the steps 1 – 6 to set additional deletion.
A. Select Deletion Set Number
1
st
Set
2
nd
Set
3
rd
Set
4
th
Set
5
th
Set
6
th
Set