54
Operation
MAB 825/845
ENGLISH
Rotating mechanism (MAB 845 only)
In order to permit optimum alignment even in difficult positions,
the model MAB 845 is additionally equipped with a rotating
mechanism. It allows the upper part of the machine to be rotated
by 30° to both sides and by 20 mm forwards and backwards with
the magnetic foot engaged.
Loosen the locking device of the rotating mechanism (13).
Position the upper part of the machine laterally and longitu-
dinally.
Lock the rotating mechanism again.
CAUTION
Operate the machine only with the rotating mechanism
►
locked.
Drilling with the machine
Drilling with twist drills
Proceed as follows when drilling with twist drills:
Push twist drills with MK taper from below into the morse
taper (3) of the machine.
Push twist drills with straight shank into the drill chuck after
fitting the drill chuck.
Position the machine at the working location, align it and
switch on the magnetic clamps.
Select the appropriate speed and switch on the machine.
NOTE
Observe the following instructions when drilling with twist drills:
Under high pressure, the drill can glow out and the machine
►
can be overloaded.
Pay attention to a regular chip discharge. With larger drilling
►
depths, break the chip.
CS Unitec, Inc.
, 22 Harbor Ave., Norwalk, CT 06850 •
Toll-free:
800-700-5919 • Ph: 203-853-9522
Fax: 203-853-9921 •
Email:
Website:
www.csunitec.com
