Unit USP-1010D, Instruction Manual

Page: 7 / 30

7
valve left or right
3 Steam leaks off the Lid There isn't a sealing gasket in the Lid Put the sealing gasket into the Lid
(see ―Appliance use‖ paragraph)
The sealing gasket isn't clean Clean the Sealing Gasket
The sealing gasket is damaged or
deformed Change a broken or deformed
Sealing Gasket to a new one in a
UNIT service center
The Lid isn't fixed properly Fix the Lid properly
4 Indicating lights are not on The appliance isn't powered on Check the power cord and the plug
Some other problems Send the appliance to a UNIT
service center
5 E1 Open circuit of the sensor Send the appliance to a UNIT
service center
E2 Short circuit of the sensor
E3 Over-temperature
E4 Disable signal switch
SPECIFICATIONS
Model Rated Voltage Power Capacity Diameter Working
Pressure
USP-1010D 220-240 V 900 W 5 L 22 cm 40-70 kPa
Max Pressure Keeping warm
Temperature
Pre-set Time Pressure-
keeping Time Max keep
warm Time
Lifetime
80 kPa 70-80 ºC 0-24 hours 1-60 min 0-24 hours 20000 cycles but not
more than 5 years from
the date of the perchase
Manufactured by: «UNIT Handelsgesellschaft m.b.H.»
131, Gersthofer Str., A-1180, Vienna, Austria
This appliance should be stored and used under the following conditions: temperature – not less than 5°C; relative
humidity - not more than 80%; aggressive impurities in the air: not allowable.
As the Manufacturer is constantly working on improvement of its products, the design and technical
specifications can be changed without prior notice.
www.unit.ru