U N I Q U E U G P 3 0 G
29
Repair Parts
When repair parts are needed, contact the dealer from whom the range was
purchased. In case your range was purchased from a source other than an appliance
dealer, you may prefer to contact the manufacturer at the address shown in this
manual.
Moisture
During the initial heat-up of your range, the heat mixing with the cooler air in the
oven cavity may produce fogging of the door glass or a collection of water on the
door. To prevent this, open the oven door for the first few seconds of initial oven
heat-up. This will allow the moist air within the oven to escape, without the forming
of visible moisture on the range. The amount of moisture will depend upon the
humidity of the air and water content of the food being cooked. Fogging and even
dripping water will usually occur in geographic locations of high humidity.
LIFT-OFF DOORS
Lift-Off Oven Door
(on some models)
The oven door is removable but it is heavy - you may need help removing and
replacing the door.
To remove the door,
open it to the full open position. Raise the locking mechanism
by applying force to the locking mechanism lever. Needle nose plyers can also be
used to lift up on the locking mechanism. Raise the oven door until each locking
mechanism lines up with the hinge cut out on the door. Grasp firmly on each side
and lift the door straight up and off the hinges.
To replace the door,
position the slots in the bottom of the door squarely over the
hinges. Then lower the door slowly and evenly over both hinges at the same time.
Once at the fully open position, press locking mechanism back in place and close the
door.
