11
Installing your
iColor coater
- Electrical
Once you have placed your
iColor coater
it is time to install the equipment. The
iColor coater
can be
installed by Certified
iColor
Technician /
iColor
Dealer or by the customer after reading and
following
the detailed directions provided in this manual.
CAUTION:
A licensed / certified electrician MUST connect the
iColor coater
to the plant power.
1. Place the
iColor coater
in the desired operating location. Remember to provide at least 3 feet (1
meter) of space around
the
iColor coater
for operation and service.
2. The
iColor coater
is equipped with approximately 8ft of electrical cord.
3. Have the Electrician connect the
iColor coater
cord to the existing plant power.
4. If it is necessary to hardwire the equipment, it is very important that it is completed by a licensed /
certified electrician.
WARNING:
Once the power is connected, be sure to have the Electrician check with an electri-
cal meter prior to turning the system on. Too much power will blow the breaker or cause severe
damage to the equipment. Too little power and the system will not power up.
Figure - Electrical cord
