15
9)
When [Pushbutton method] is displayed, select [Yes] and press the «ENTER» button.
•
The printer starts searching for wireless LAN access points. The "Running push button method..." message is
displayed on the screen.
10)
Press and hold WPS button on the wireless LAN access point for a few seconds while the message is displayed.
11)
When [WPS connection successful.] is displayed, it indicates that the wireless LAN setup has completed.
12)
If the antenna mark is displayed at the top right of the display screen, the connection is established correctly.
•
If [Connection failed. Timeout] is displayed, repeat the procedure from step 6.
Configuring Settings Using the Operator Panel
•
If the wireless LAN access point does not support WPS, you can specify a wireless LAN access point you want to
use from the wireless LAN access points that the printer detects to establish a connection. In such a case, you
must enter an encryption key.
1)
Follow steps 1 – 6 as indicated in the above Connecting with WPS section.
2)
Press the scroll button several times to select [Wireless Network Selection] and press the «ENTER» button.
•
The printer will search for available wireless LAN access points. This may take a minute or two.
3)
A list of available wireless LAN access point SSIDs are displayed. Press the up or down scroll button and select a
wireless LAN access point to connect, and then press the «ENTER» button.
•
If only [Manual Setup] is displayed, or the SSID of the wireless LAN access point you want to use is not included in
the list, set it by following the procedure in the next section ‘Connecting by Manual Setup from Operator Panel’.
4)
Enter the encryption key, and then press the «ENTER» button.
5)
When ‘Connection successful.’ is displayed, select [Close], and then press the «ENTER» button.
•
If ‘Connection failed.’ is displayed, repeat the procedure from step 2.
•
If the antenna mark is displayed at the top right of the display screen, the connection is established correctly.
Configuring Settings Using the Operator Panel
•
Set the wireless LAN access point information (the SSID, encryption method and encryption key) manually to
connect to the wireless LAN.
1)
Check the SSID, encryption key, and encryption method by referring to the instruction manual that is included in a
wireless LAN access point or other documents, and write the information down.
2)
Follow steps 1 – 6 as indicated in the above Connecting with WPS.
3)
Press the scroll button several times to select [Wireless Network Selection] and press the «ENTER» button.
•
The printer will search for available wireless LAN access points. This may take a minute or two.
4)
A list of available wireless LAN access point SSIDs are displayed. Press the scroll button or, select [Manual Setup]
at the end of the list, and then press the «ENTER» button.
5)
Enter the SSID you checked in step 1, and then press the «ENTER» button.
