Unigas E140X, Manual Of Installation - Use - Maintenance

Page: 33 / 131

PART III: OPERATION
33
To enter the Info level, proceed as follows:
1 in any menu position, press keys + and - at the same time, then the program will start again: the display will show OFF .
2 until the display will show InFo , Press the enter (InFo) key
3 then il will show the first code (167) flashing, on the right side it will show the data entered. By pressing + or - it is possible to scroll
(up or down) the parameter list.
4 If a dot-line is shown on the right, there is no enough room for complete visualisation: press enter again the data will be completely
shown for 1 to 3 seconds. By pressing enter or + and - at the same time, the system will exit the parameter visualisation and go
back to the flashing number.
The Info level shows some basic parameters as:
5 Example: choose parameter 102 to show the date
the display shows parameter 102 flashing on the left and characters ._._ on the right.
6 press InFo for 1-3 seconds: the date will appear
7 press InFo to go back to parameter “102”
8 by pr / -, it is possible to scroll up/down the parameter list (see table above), or, by pressing ESC or InFo for more seconds,
the display will show
9 Once the last parameter is accessed (143) by pressing + , the End message will flash.
10 Press InFo for more than three seconds or for more than three seconds orto return to the normal display.
Parameter Description
167 Cubic meters of fule (resettable)
162 Operating hours (resettable)
163 Device operating hours
164 Burners start-ups (resettable)
166 Total number of start-ups
113 Burner number (i.e. serial number)
107 Software version
102 Software date
103 Device serial number
104 Customer code
105 Version
143 Free