UniFlow microMIND V2, Installation & Configuration Manual

Page: 17 / 42

LED Status
The microMIND V2 is equipped with two status LEDs. The tables below show the status
information given by the respective LED.
Power LED:
Status/Colors Status Descriptions
Off No power supplied or boot loader phase (see also chapter Firmware
Update).
Green Device is powered with power over Ethernet (PoE).
Orange Device is powered with an external power supply.
Status LED:
Status/Colors
Status Descriptions
Off The microMIND V2 did not boot. It is most likely defective.
Green A MiCard/MiCard PLUS card reader is connected and has been
identified. The microMIND V2 is ready to receive data from the
MiCard/MiCard PLUS.
Note that the green status only appears, if the microMIND has been
configured with a printer in uniFLOW.
Green flashing No USB card reader is connected. This status will only be displayed if
the microMIND V2 is connected to the network and to a uniFLOW
server.
Green flashing (fast) If a new firmware has been loaded successfully during the boot
loader phase, the green LED is flashing fast (see also chapter
Firmware update (on page 14)).
Orange A card has been detected by the MiCard/MiCard PLUS reader and
the uniFLOW server has been informed about it. This status is shown
for approx. 2 seconds. Afterwards the LED turns green again. It also
lights up in orange during the boot loader phase.
Orange flashing A not supported USB card reader has been connected. Note that
only MiCard/MiCard PLUS readers are supported by the microMIND
V2. MiCard PLUS readers are supported since firmware V2.0.5.
Red The microMIND V2 has an IP address but is not connected to a
uniFLOW server nor to an RPS, thus it is inoperable.
Red Flashing The microMIND V2 has no IP address and is trying to acquire an IP
address, thus it is inoperable.
RJ45 LED:
5
LED Status
4