Uniden XDECT 8155 Series, Owner'S Manual

Page: 11 / 68

11
Testing the Location
Place the repeater in its final position and connect the AC adaptor. The
LINK light will flash for a few seconds, then stay on.
If... Try...
the Link light
doesn’t turn on
•
checking the repeater’s AC adaptor
•
connecting the adapter to a different outlet.
the
Link
light
continues flashing
•
making sure the repeater is not near
electronic devices that can cause
interference.
•
making sure there are no thick walls or large
metal objects between the repeater and the
base; these can block the signal.
•
making sure there is no other base or
repeater within 10 m of this location.
Move further away from the base and make a test call on a cordless
handset.
If... Try...
the call won’t connect re-registering the repeater.
there is a lot of noise
on the call
moving the repeater closer to the base.
Placing the Repeater on the Wall
You can mount the repeater directly to a wall using the horizontally aligned
mounting slots at the back of the repeater unit. Before doing this consider
the following:
•
Avoid electrical cables, pipes, or other items behind the mounting
location that could cause a hazard when inserting screws into the wall.
•
Mount the repeater within distance of a working 240V AC power outlet.
#
The Repeater unit is NOT waterproof. If mounted onto an outside
wall place under an eave or roof overhang where it is protected
from direct weather conditions, DO NOT place in direct sunlight.
1. Insert two #10 screws into the wall, 57 mm apart. Leave the heads of the
screws about 6 mm away from the wall. (For best results, use a level to
ensure the screws are even.)