Uniden XDECT 8155 Series, Owner'S Manual

Page: 7 / 68

7
If... Try...
the CHARGE light
does not turn on
•
reseating the handset
•
checking the AC adaptor
connection
•
seeing if the outlet is controlled
by a wall switch
#
Charge all handsets completely (about 15-20 hours)
before using them.
Test the Connection
1) Pick up the handset from the cradle and press
HOME/FLASH.
You
should hear a dial tone, and the display should say
Talk
.
If... Try...
you don’t hear a dial
tone or the display
says
Check Tel Line
checking the connection between the
base and the phone jack.
2) Make a quick test call. (Press
END/CLEAR
to hang up.)
If... Try...
there’s a lot of
noise or static
see page 45 for tips on avoiding
interference.
3) Test any accessory handsets the same way. If you can't get a dial
tone or the handset display says Unavailable , try moving the handset
closer to the base or resetting it (see page 48). Charge all handsets
completely (about 15-20 hours) before using them.
Connect the Telephone Cord
Use the telephone cord to connect the TEL LINE jack to a standard
telephone wall jack.
Installing the Belt Clip
Line up the holes on each side of the handset. To attach the belt clip, insert
into the holes on each side of the handset. Press down until it clicks. To
remove the belt clips, pull either side of the belt clip to release the tabs
from the holes.