Uniden UBCD996T, Owner'S Manual

Page: 109 / 148

109
Setting the Delay Time
Setting the Search Frequency Step
Setting Record
Adjust P25 Level
[MENU]
[MENU]
[MENU]
RECORD OUT
This setting determines how long the scanner waits after a transmission ends before
resuming Quick Search or Close Call operation.
— The scanner waits the set amount of time after the transmission ends
before resuming. The default setting is 2 sec.
— The scanner resumes immediately when the transmission ends.
This setting lets you select the frequency step used for setting the channels.
— The step is based on the band (see the table at the front of the manual).
This is also the default setting.
You can set the RECord Output jack to provide an audio signal to a sound recording
device (tape, PC, flash memory) for live recording of transmissions.
— enables an output to an audio recorder at the jack.
— disables an audio signal at the output jack.
You can select the best threshold for the APCO mode.
g Q g
g
g Q g
g
g Q g
g
Q
Q
Q
Srch/CloCall Opt
Set Delay Time
1-5 sec
Off
Srch/CloCall Opt
Set Step
Auto
5.0 kHz, 6.25kHz,
7.5 kHz,8.33kHz,
10.0 kHz, 12.5 kHz,
15.0 kHz, 20.0 kHz,
25.0 kHz, 50.0 kHz,
100.0 kHz
Srch/CloCall Opt
Set Record
On
Off
The scanner uses the selected step.