Uniden UBCD996T, Owner'S Manual

Page: 102 / 148

102
Set CC Bands
VHF Low 1
VHF Low 2
Air Band
VHF High 1
VHF High 2
UHF
On Off
— Lets you select the Close Call band settings. You can turn the
following bands on or off.
(25.0000 - 53.9800 MHz)
— (54.0000 - 107.9000 MHz)
— (108.0000 - 136.9875 MHz)
— (137.0000 - 224.9800 MHz)
— (225.0000 - 319.9750 MHz)
— (320.0000 - 512.0000 MHz)
— (764.0000 - 775.9875 MHz, 794.0000 - 956.0000 MHz,1240.000 -
1300.0000 MHz)
Use the to select a band, press , then use the
to select or and press . Turning off undesired bands speeds up
Close Call operation (works for all frequencies listed above).
When the scanner detects a Close Call hit, it alerts you according to the Override
and Alert settings in the previous section.
While listening to a Close Call hit, you can press to hold on the hit
frequency, press to quickly save the frequency into memory, press to lock
out the frequency from Close Call and Search operation, or wait for the transmission
to end. If you are in Close Call Only or Close Call Override mode, and you do not
press any key, the scanner returns to its previous operation after the transmission
ends and the set delay time expires.
If you are holding on the frequency, press again to resume the
previous operation.
Close Call Hits are just the last 10 hits received in Close Call mode. The hits go
away when you cycle power (if you want to store it “permanently” press when the
scanner is on the frequency; the scanner then stores the frequency into the “Close
Call” system which does show up in the systems list).
When you turn on this option, the scanner automatically stores and scans the last 10
Close Call hits received. You can assign a Quick Key to this special scan and you
can also set how long the scanner will wait after the signal stops before
—
Scroll Control Scroll
Control
[HOLD/RESUME]
[L/O]
[HOLD/RESUME]
Q
Close Call Hits
Close Call Hits with Scan