78
IP Filter
IP filter interface is shown as below.
You can add IP in the following list. The list supports max 64 IP addresses.
System supports valid address of IPv4 and IPv6. Please note system needs to
check the validity of all IPv6 addresses and implement optimization.
After you enabled trusted sites function, only the IP listed below can access
current NVR.
If you enable blocked sites function, the following listed IP addresses can not
access current NVR.
Enable
: Highlight the box here, you can check the trusted site function and
blocked sites function. You can not see these two modes if the Enable button
is grey.
Type
: You can select trusted site and blacklist from the dropdown list. You can
view the IP address on the following column.
Start address/end address
: Select one type from the dropdown list, you can
input IP address in the start address and end address. Now you can click Add
IP address or Add IP section to add.
a)For the newly added IP address, it is in enable status by default. Remove
the √ before the item, and then current item is not in the list.
b)System max supports 64 items.
c)Address column supports IPv4 or IPv6 format. If it is IPv6 address, system
can optimize it. For example, system can optimize aa:0000: 00: 00aa: 00aa:
00aa: 00aa: 00aa as aa:: aa: aa: aa: aa: aa: aa.
