Uniden DECT1825, Owner'S Manual, Page: 6 / 48

Preparing the handsets
Battery Performance
Installing and charging the handset batteries.
1
Remove the battery compartment cover.
Press down on the semi-circle indent and slide
the cover off.
Connect the supplied battery pack with the
correct polarity.
Slide the battery cover back until it clicks
securely into place.
2 To charge the battery, place the handset(s) on
the base or on a charger. The charging light in
the base illuminates. While charging, the symbol
scrolls and when the handset is fully
charged, all the bars of the battery symbol will be
filled when the phone is off the cradle.
If the charging light does not come on, reposition
the handset in the base or charger, ensuring that
the charging points contact. You must charge
each handset for 15-20 hours before use.
The handset may become warm during charging,
this is normal. On a single charge your handset will
give 16 hours talk time and 7 days standby time.
New NiMH batteries does not reach its full capacity
until it has been in use for several days.
Over time, as the batteries wear out, the charge
capacity will reduce, so reducing the talk/standby
time of the handset.
Eventually the batteries will need to be replaced.
On each handset:
CHARGE BATTERY
WARNING
BATTERY LOW WARNING
Under no circumstances should non-
rechargeable batteries be used. Only use the
supplied battery pack or you will invalidate your
guarantee and may damage the telephone.
If the symbol is displayed on the handset,
appears and you hear the low
battery tone, you will need to recharge your
handset.
We recommend that you place the handset back
on the base/charger between use to ensure that
it is always fully charged.
[5]