Uniden DECT1825, Owner'S Manual, Page: 28 / 48

1 Press to access the main menu.
2 Press or until is
displayed and press .
3 Press or to select
and press .
4 Press or to display
and press . The current setting is
displayed.
5 Press or to select 80, 100, 120,
180, 250, 300, 600, and 800msec and press
to confirm.
6 Press to exit and return to standby.
Note: Pulse dialing is not available for NZ model -
selecting Pulse option will save as Tone dialing.
You can set your phone to use either Tone or Pulse
dialing. The pre-set setting is TONE dialing, where
you will hear a tone beep each time you dial a
number. Most modern exchanges and switchboards
use Tone dialing, so you should not need to change
this setting. Only change it if your switchboard uses
Pulse dialing or if you cannot make a call using
Tone dialing.
1 Press to access the main menu.
2 Press or until is
displayed and press .
3 Press or to select and
press .
4 Press or to display
and press .
The current setting is displayed.
5 Press or to display either or
and press to confirm.
6 Press to exit and return to standby.
If you have set your phone to use Pulse dialing, you
can switch temporarily to Tone dialing for the
duration of a call:
1 Press .
2 Enter the number you want. Press and hold
D will be displayed.
Any digits entered after the D will be dialed
using tone dialing.
Base Settings
Additional
Recall Time
Base Settings
Additional
Dial Mode
Tone
Pulse
Dial mode
Tone Dialing Switch-Over
menu/ok
menu/ok
menu/ok
menu/ok
menu/ok
menu/ok
menu/ok
menu/ok
menu/ok
menu/ok
rdl
rdl
rdl rdl
rdl
rdl
rdl
rdl
rdl
end
end
talk
[27]