Uniden DECT1825, Owner'S Manual, Page: 29 / 48

Registering a new handset
When you register a new handset to your base, you
will be asked to enter the base PIN code.
The pre-set PIN code is 0000. If you wish you can
change this code, see page 29.
Each handset can only be registered to one base at
a time. Before registering, make sure the new
handset is fully charged and that you have the base
and handset in front of you.
Also, make sure all handsets and the base are in
standby mode.
1 Press to access the main menu.
2 Press or until is
displayed and press .
3 Press or to display and
press
4 Press or to select your base
number and press .
5 Press and hold for approx. 3 seconds until
you hear the registration tone. You are now in
‘registration mode’.
If the base already has the maximum number of
handsets (6) registered to it you will need to de-
register one of the existing handsets before you can
register the new handset.
See section below for de-registering handsets.
Enter the base PIN code.
Pre-set base PIN code is 0000.
You will hear a confirmation tone when
registration is complete.
When in standby mode, the new handset number
will be displayed.
The handset will automatically be allocated with
the next available handset number.
If registration is unsuccessful, the display will show
and you will need to follow the
registration procedure again.
On the handset you want to register:
On your base:
On the handset you want to register:
Add.settings
Register
Not Registered
menu/ok
menu/ok
menu/ok
menu/ok
rdl
rdl
rdl
[28]