Uniden BCD436HP, User Manual

Page: 63 / 112

57
Channel Options
Select Service Type
This sets the Service Type for The Channel.
The Appendix has a list of Service Types and their general descriptions.
Default is
Custom 1 .
Scroll to the Service Type and press E/yes .
Set Delay Time
This sets (in seconds) the amount of time the scanner stays
on a channel after the transmission has ended before moving to the next channel.
A negative delay will force a resume after that number of seconds.
The default setting is
2 seconds.
-10 , -5 , -2 , 0 , 1 , 2 , 5 , 10 , or 30 sec.
Set Priority
This sets the channel as a priority channel while scanning. The
default setting is Off . Note: To use Priority ID Scan you must also enable Priority
ID Scan for each System. See also Priority Scanning.
On or Off
Set Alert
This setting controls when and how the scanner alerts you if the
channel becomes active. The default setting is Off .
Set Alert Tone
Alert 1-9 or Off.
Set Level
Level 1-15 or Auto (the master volume level).
Set Alert Light
Set Color
Off, Blue, Red, Magenta, Green, Cyan, Yellow, or White.
Set Pattern
On, Slow Blink, or Fast Blink.
Set Avoid
This determines whether a channel will be scanned or not.
Temporary L/O means until you cycle power. The default setting is Unlocked .
Temporary Avoid , Stop Avoiding , or Avoid
See also Scan Avoids.
Volume Offset
This sets the Volume Offset for the Channel.
-3, -2, -1, 0, +1, +2, or +3
Note: You can also toggle volume offset for a channel in scan hold mode by
pressing Func then 0(
LVL
) .
Delete Channel
Deletes the Channel.
At Confirm Delete? press E/yes or .no .
New Channel
See New Channel.