E-10
Uniden Atlantis 290/295 Radio Owner’s Manual
INSTALL ALKALINE BATTERIES
The radio also comes with an accessory battery tray that
holds four AAA-type Alkaline batteries (not included). .
NOTE: When using Alkaline batteries, transmit power is
limited to MID or LOW power.
Follow these steps to use the accessory battery tray:
1. Align the batteries’ positive and negative terminals with
the markings on the case and snap each battery into
place.
2. Line up the battery’s connector with the jack inside the
battery compartment (the connector only fits one way).
3.
Push the connector in firmly. Tug on the battery wires
gently to make sure you have a good connection.
4. Seat the battery case in the battery compartment.
5. Before replacing the battery cover, check the rubber seal
located on the under side of the cover; make sure that
the seal is set in the groove and that there is no foreign
matter under the seal.
WARNING! The accessory battery tray is designed to
prevent the accidental charging of non-rechargeable
batteries. Never use non-rechargeable batteries in the
radio without the accessory battery tray.
6. Replace the battery compartment cover. Tighten the
screw securely.
MOUNT THE CHARGER
You can mount the charger on any flat surface.
1. Use the two holes at the base of the charger
as a template to mark the drill holes.
2. Using a 1/8-inch (or 3 mm) drill bit,
drill two holes 1/2 inch (13mm) deep.
3. Use the provided screws to attach the
charger to the surface.