Operation
PG-I Series | Version 1.03
19
Fig. 32: Venting tank cap
Step 2: Turn the knob for the fuel tap to "ON".
Fig. 33: Open fuel tap
Step 3: Turn the choke lever to the "CHOKE" position
Fig. 34: Actuate choke
Step 4: Turn motor switch to "START" and "RUN" posi-
tion.
Fig. 35: Operate motor switch
Step 5: Run the engine warm without load until it runs
smoothly and smoothly.
Step 6: Push the choke lever back to the "RUN" position.
Fig. 36: Actuate choke
9.2 Switching off the generator
Step 1: Switch off or interrupt all consumers supplied by
the generator.
Step 2: Disconnect the mains plug of the electrical
consumers from the generator.
Step 3: Run the motor for 2-3 minutes without load, then
set the energy saving switch and the motor
switch to "O" or "Off".
Step 4: Turn the fuel tap or tank ventilation to "O" or
"Off".
9.3 Workflow
Step 1: Let the engine warm up for a few minutes.
Step 2: Add up the power (watts or amperes) of the
electrical consumers. The sum must not ex-
ceed the capacity of the generator or fuse.
Step 3: Plug in the electrical consumer(s). The consu-
mers must be switched off.
Step 4: Switch on the electrical consumer(s).
Engine
switch
Engine
switch
DANGER!
Even after the engine has been switched off, it still
emits heat, so adequate ventilation should be provi-
ded even after the generator has been switched off.
DANGER!
If the connected loads overheat, switch them off and
disconnect them from the generator.
