17
To do this, unscrew the cover (M)
(cleaning it thoroughly in advance, so that no dirt gets inside), and remove it together with the
bearings. Move the toothed wheels (K) off the spline shafts and shift their positions. Then, put on the
gear cover and screw it on.
Pay attention to the correct position of the gasket.
More intensive soil crumbling can also be achieved by increasing the speed of travel, but the power
demand increases. However, never exceed max operating speed specified by the manufacturer in the
machine operating manuals.
CAUTION
!
POSSIBILITY OF BURNS
If replacement of wheels takes place immediately after interrupted work, wait until the transmission
has cooled down. Remove the PTO drive shaft from the tractor after stopping the tractor engine and
removing the keys
.
8. Work with HERMES Unit and Operating Conditions
Safety instructions, section 4
Observe the following rules in order to achieve the correct effects of the cultivator unit operation:
1.
Ensure that the machine is correctly attached to the tractor.
2.
Read this OPERATING MANUAL thoroughly
3.
Check the condition of screw connections and condition of working
components before
driving to the field
4.
Check and adjust the working depth, if required
5.
Keep an even speed
6.
Always clean the machine after finishing work
7.
Replace defective parts with original, new ones, as soon as possible
8.
At the headlands, raise the unit to a height that allows the manoeuvre to be performed
without hitting of the working components against the soil
9.
Drive the unit in a straight line during subsequent passages, without underlap. When
working with the
seeder, drive the machines following the traces of the seeder
markers
9.
Avoid sudden jerks
10.
Repair any defects immediately after their detection
11. Avoid w
orking on stony soils
12.
Use the right lubricants and observe the lubrication intervals, according to the lubrication
chart (par. 8.2.2)
13.
Check the tightening of the bolts and nuts every 30 hours of operation. Tightening torque for
knife fixing bolts
– 350 Nm
Summary of Contents for HERMES 3.0
Page 2: ...2 ...
Page 22: ...22 UWAGI I NOTATKI ...
