UTG2000B Series 75
Figure 3 - 7 Select SUM function
(2)
Select carrier waveform
After enabling SUM function, press Carrier
→
Type
→
Square . You can press Param again until
the following interface appears.
Figure 3 - 8 Set modulation parameter
(3)
Set FSK rate and modulation phase
After setting up, press Return to turn to the interface below:
4)Use channel output
Press CH1 button start channel 1 output quickly. Or enable output by pressing Utility and then CH1
Setting . After channel output is opened, backlight of CH1 button is on, and on the right side of channel
information label, the font “OFF” changes to “SUM”, meaning open channel output.
Summary of Contents for UTG2122B
Page 2: ......
Page 129: ...UTG2000B Series 127 This user manual may be revised without prior notice...
Page 130: ...128 UTG2000B Series...
