Service Manual UTG1000X Series
Instruments.uni-trend.com
16
/
20
7
、
Remove the keyboard; use a T10 Torque screwdriver to remove the two switch key screws, and then
remove the 8 fixing screws of the keyboard to remove the keyboard and the screen.
Note: Before removing the keyboard, the knob on the front panel needs to be removed.
8
、
To reinstall, reverse the above steps.
Removing the rear panel assembly
The following procedure describes the removal and replacement of the rear panel assembly.
Prerequisites:
To prevent electrostatic damage to components, wear a properly grounded antistatic wrist and foot
strap during installation, and use an antistatic mat in a tested antistatic environment.
Remove the rear cover.
Steps:
1. After step 3 of removing the front panel, gently pull the rear cover to remove it, as shown in the figure
below:
2. Remove the power module; use a T10 Torque screwdriver to remove the 6 screws and the wiring harness,
as shown in the figure below:
