Page 22 of 27
UT
D
4000 Digital storage oscilloscope communication control software
Operating
Manual and Installation Guide
button is turned “OFF”, the indicator light will go off, as shown in Fig 3-2.
Fig 3-2 ON/OFF status display of the equipment selection button
3.
Click the [Data Transmission] button to turn it on. When the indicator light comes on the function is
ON. When the indicator light goes off the function is OFF, as shown in Fig 3-3. When data
transmission is on, you can operate the digital storage oscilloscope with the buttons and knobs on
the control panel. The parameters and setups of the virtual control panel will change accordingly.
Fig 3-3 ON/OFF status display of the data transmission button
4.
When data transmission is complete, Click the [Data Transmission] button again to turn it off.
During data transmission, you cannot operate the oscilloscope with the software. The function keys
on the virtual control panel are disabled but they continue to indicate the current status of the
oscilloscope.
5. Enter the “Far control” and click the [Far control] button. The indicator light comes ON.
Transmission interface mode is now enabled, as shows in Fig 3-4.
Uni-Trend Technology (Chengdu) Ltd
Fig 3-
4
