USER MANUAL - URS600CE AND URS600CESS JULY 2019
18
6
WARNING
If there are doubts about the safe use of your machine, always contact your
supplier or Uni-ram Corporation before operating it.
Please note!
The solvents which have been/will be recycled may be flammable. Set up and follow safe
work practices for storing and transporting these solvents.
Give everyone who works with the machine clear instructions about working safely in accordance with
Health and Safety legislation and also with this manual’s instructions regarding installation, use and
maintenance.
For the safe use of the URS600CE, you must comply with your obligations in accordance with the ATEX
Directive 153 (Directive 1999/92 / EC) about explosion protection. If you do not comply with these
obligations or you are not familiar with this Directive, you may not use the URS600CE. We advise you to
seek advice from an expert ATEX advisor.
Check the lid gasket for damage before each use. A damaged lid gasket leads to poor sealing and vapour
leakage, which is dangerous and wasteful.
3.2. Requirements for recyclable solvents
The contaminated solvent that is to be recycled must meet the following requirements:
• The boiling point of the contaminated solvent is below 200°C. The boiling point increases as the
contamination increases.
• The auto-ignition temperature* of the solvent is higher than 280°C.
• The solvent has recently been contaminated, stagnant solvent can be acidic. The solvent is suitable for
distillation.
Check the material Safety Data Sheet (SDS) from your solvent supplier beforehand for the flammability,
autoignition point, toxicity and boiling point of the solvent. If you do not have these at your disposal,
always ask for this from your supplier in advance.
6
WARNING
Only recycle solvent mixtures with a self-ignition temperature above 280°C. For example,
any mixture containing nitro-cellulose should not be recycled because it may self-ignite
at 135°C.
6
BE CAREFUL
Do not recycle acidic or chlorinated solvents as they can damage the machine and
jeopardize safe operation.
* Auto-ignition temperature: The temperature at which the liquid ignites itself, without the need for a flame.
3.3. Place the liner bag in the Tank
Only use original the bag retainer ring and original liner bags for the URS600CE.
Please note!
One extra liner bag is supplied as a spare part, but order new ones before they run out. To do this, use part number:
Liner bag - LB900C-10.
On delivery, the tank of the URS600CE comes equipped with an installed liner bag and a bag retainer ring. With the first use you
can proceed to section 3.4. The liner bag can only be used once. If the liner bag needs to be replaced, please follow the next
steps.
Open the safety cover of the URS600CE completely.
1. Unlock the tank lid clamp by lifting the clamping lever and open the lid.
WARNING
BE CAREFUL
WARNING
